WELDING PART- 2

              WELDING OF CAR - PART 2

 Welding department

This department has 3 zones –

A zone

B zone

C zone

D zone

 B zone

In this b zone side panels and roof are joint a frame is being made here. B zone is where the sealing is put in the side panels to avoid air blockage and making it tight. Here pin for car is also made for the car recognition.    

Vin punching (identification no.) –

Here is unique number is being made on the front  part of a car which is its unique face. This process of engraving is made by grinding on it. This is a separate part not in going procedure.

Here in this zone our welded floor is in preset, here roof and dash upper are placed and side comp and side panel are welded and made at the right as well as on the left side.here the parts are welded at different sides. Sealer is also added and in the side comp rear inner a thin sheet part is also welded and in side comp side panel is also welded. Now this all parts are put at their places and a robot is their which fit and weld all these parts side panel, side comp, roof, dash upper . here this robot welds the parts a frame is being ready now the farme is ready to go to C zone .